New dado insert for my Skil 3410 table saw

***UPDATE 10-23-20***  Thank you to Kiel Herman who posted a current order link in the comments.

CLICK HERE to order

I recently wrote a post on making a zero clearance insert plate for my table saw.  The main reason that I made that insert was because I could not find a dado insert made for my table saw.  I did some more searching and finally found one on eReplacementParts.com.  In the description it gave the model number for the part it was replacing.  I then took that model number and plugged it into the search on the Skil site and was able to find the OEM part!  It did not give a picture and only gave a description of “Dado Insert Kit for 3410 Table Saw”.  The after market website had a small picture that showed a nut and washer so I was cautiously optimistic that this one would come with one too.  It turns out that it did come with a new washer/nut combo for the arbor that is slimmer and I can now install my full dado stack!

Here’s the pic from the after market website.
I felt like a kid on Christmas when it finally got here.
That was a pretty big box just to ship this little one but it

got here safe!

 Out of the box.
No question about it, it’s made for my table saw!
Here it is with a nut/washer combo and another washer that replaces

the one on the other side of the blade.

Here’s all my inserts.
This is the zero clearance insert that I made.
Here is the new one installed with a 1/2″ dado stack.  There is plenty of room

to fit in the whole 13/16″ stack!

Here is the old washer/nut combo next to the new one.

14 Replies to “New dado insert for my Skil 3410 table saw”

Holly Natwora

July 8, 2019 at 12:06 pm

Help! I can not find the dado insert for my skil 3410 table saw. Evidently it has been discontinued while the saw is still being sold. Every website states the part is currently unavailable.

Reply

Laurel Nichols

August 16, 2019 at 4:17 am

Can you tell me what the replacement part number is or something so I can order one of these please

Reply

Jeremiah

January 20, 2020 at 6:28 pm

Toolmarts.com just delivered a factory dado kit to me. After reading many comments around the web, I took a chance and this website came through for me. Hopefully its not to late.

Reply

Kiel

September 28, 2020 at 1:32 pm

What did you make your zero clearance insert out of, and how thick is it?

Reply

    admin

    September 28, 2020 at 3:09 pm

    I made it out of 1/8″ thick hard board.

    Reply

Post Your Comment Here

Your email address will not be published. Required fields are marked *