Shop update #471 (11-18-26)

It turns out that glueing and clamping the boxes made the top opening just smaller enough that the lids wouldn’t fit.  I had to reset the laser and cut about a millimeter and a half off of each lid, which was a giant pain in the butt, but it was better than having to remake all of them.

Once the lids fit on, I sanded them all down with 220 grit sandpaper and eased all of the edges and corners.

I then wiped them all down and gave them a couple of coats of a beeswax and oil finish.  The customer was very happy to get them.

Post Your Comment Here

Your email address will not be published. Required fields are marked *