New Yankee Workshop Workbench update – cutting the plywood benchtop
The plans called for making the benchtop out of 3/4″ plywood. I’ve had this sheet of 1/2″ plywood in my
Zero clearance table saw insert
I had put off working on the New Yankee workbench because I didn’t have an insert for my table saw
New Yankee Workshop workbench update
I was able to get quite a bit of work done on the bench this weekend. On Saturday I fixed
New Yankee Workshop workbench update
I was able to get quite a bit of work done on the bench this weekend. On Saturday I fixed
I finally made some progress on the New Yankee Workshop workbench
I started the workbench build back at the beginning of the year by cutting all the 2×4’s down to length.
I finally made some progress on the New Yankee Workshop workbench
I started the workbench build back at the beginning of the year by cutting all the 2×4’s down to length.
My new dado set
I installed my new 8″ dado set into my Skilsaw 3410 contractor table saw today. It turns out that the
The first thumb chair is done!
I finally finished the first thumb chair! Why do these projects always seem to take so long? I forgot to
Table Saw Blade Selection
I went to Lowes yesterday to pick up a small detail sander with a gift card from my wife. While
Last minute Valentine’s present. A gift box!
Back in November of 2012 I picked up a few 1x6x24 1/2″ thick boards so I could enter A Simple