Shop update #228 (3-9-22)

I finished the giant 4 ft x 8 ft folding table!

My friend and I picked up a full sheet of 3/4″ plywood from Home Depot and set it up on sawhorses in his garage.  We then built the frame for the table on top of it.

Once the frame was built I drilled 3/8″ holes through the sides and into the legs.  I measured incorrectly on one of the legs and had to plug it with a piece of dowel.

I then marked and predrilled the holes on the bottom of the legs for the casters.

Once the casters were mounted we flipped the table over, screwed the plywood down to the frame,  and tested it out.

I also made my first cutting board with a handwritten recipe laser etched onto it.